Pickling Spray (Semi-Gel Form)

Semi - Gel in texture, Spray is used to clean large fabricated stainless steel equipments like storage tanks, internal and external surfaces of tanks.

AREA COVERED

Spray form covers 40-50 sq.ft. of an area with 1 kg. of the chemical.

APPLICATION PROCEDURE FOR PASTE

Add 50 gms of SI. 56 Degreaser to 1 ltr. of water (5% w/v.). Apply solution on the surface for 10-15 minutes & then wash thoroughly and allow the surface to dry.

Spray is to be sprayed on the S.S. Surface with a pressurized plastic spray bottle or spray pump.

After spraying leave it for 30-60 minutes then scrub the surface with a plastic bristled brush.

Then wash the surface thoroughly with high-pressure water and allow the surface to dry.

Next apply Passivation solution and leave it for 20-25 minutes.

Finally clean the surface thoroughly with demineralised water and dry.

Note:
Chloride content in rinse water should be less than 50 ppm.
Shake the products well before use.
Do not apply the products on the SS Surface under direct sunlight.
Passivation is a must after every pickling process.